![]() That control module controls the steps and is connected through the OBD II port and that is nice because that eliminates the need for installing any sort of door magnets making the installation a real breeze. They feature a unique step-within-a-step - two steps in one. Step 1: The Basics of Op-Amps The good news about op-amps is that there are a few relatively simple first principles from which the behavior of any circuit can be readily deduced. ![]() It also features a weather-resistant control module that mounts in the engine bay which can stand up to the temperatures of the engine bay but also any sort of weather conditions. ActionTrac powered running boards are the ideal lifted Jeep or lifted truck power steps. Of course, the kit also features a full OEM-grade wiring harness that’s going to make the installation nice and easy and it includes the LED lights that mount on the underside of the vehicle to illuminate the steps. The articulating arms and the steps are deployed by a single motor on each side and those motors feature a protective plastic housing that’s going to help keep the gunk and the grime from the trail out of the motor. The aluminum step is coated in a military-grade high-grip powder coating that not only looks great, but it’s going to stand up to the elements and will help maintain traction in bad weather conditions. They also feature stainless steel pins for longevity and to resist corrosion, and the joints are PTFE lined to make sure you get smooth operation and long-term durability. With the step out of the way, it was 2 bolts to disconnect the drive motor, and 2 bolts to take the arm off.This system includes these die-cast aluminum articulating arms which can support up to 500lbs. I used a dead blow hammer to tap it lose. After loosening the screws that held it on, it was still stuck on. As can be seen below, the step sits in a groove on the arm with sand in it. The steps are right behind the front tire and as a result, are constantly being bombarded with sand and road grime. I could easily see the broken gear, but I needed to take the side step arm off to get to the shaft. Regardless, the shaft end broke into pieces and needed to be replaced. You can see there is some grit in the photos, but most of the dirt from sticking to the spray on grease that I use. It’s exposed to air and had the potential to get rocks and debris in it, but I’m pretty good about cleaning the extension arms. The part that broke is the shaft that goes through the steps that the motor uses to lift and lower the steps. You can find AMP Research contact info here: Broken Gear My issue is the cage is tied into the frame and I have only about 20' for the motors and steps to retract. After emailing AMP Research, the sent me the broken gear replacement within a couple of days. Im getting old and like the idea of the power steps. Fortunately, the AMP Research Powerstep comes with a 5-year warranty. I’ve seen other trucks that had their steps stuck down and it looks like crap. The AMP Research Powerstep had just chewed through a gear and my driver side step was permanently down.ĪMP Research Powersteps are not cheap, and I always had worried a little about this happening. When I got out, I found chunks of metal on the ground. I was working on my truck and when I closed my door, I heard a crunching noise and the step motor still running. I’ve had them for a little over 2 years and they have worked flawlessly…until recently. One of the first mods I did on my Toyota Tundra was to get AMP Research Powersteps.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |